- #CHANGE SD CARD SERIAL NUMBER SERIAL NUMBER#
- #CHANGE SD CARD SERIAL NUMBER UPDATE#
- #CHANGE SD CARD SERIAL NUMBER UPGRADE#
#CHANGE SD CARD SERIAL NUMBER SERIAL NUMBER#
One of these is the Card Identification (CID) Register, a 16 byte code that contains information that uniquely identifies the SD card, including the card serial number (PSN), manufacturer ID number (MID) and manufacture date (MDT).
#CHANGE SD CARD SERIAL NUMBER UPGRADE#
Step 4: Further firmware or speech feedback upgradeĪfter the above upgrade the V4 embosser may be upgraded to new firmware revisions, new speech interface languages etc by downloading the file from the Index Braille web and sending revisions to the embosser via IbPrint.Information about an SD card is encoded in its internal card registries. If the model is Everest you need to calibrate the paper movement to your paper quality, this is done in menu/system/calibration.First, is a hammer test page and the second is an embosser information page. Change the date to the date on the serial number label.Change 50000 to the serial number seen on the serial number (silver) label on the embosser.Download file File to change serial number - ESC_C-SerialNo or located in Downloads and save it on the desktop or somewhere you will remember.The serial number in the embosser needs updating. Step 3: Give the embosser correct serial number The embosser will restart automatically when the upgrade is completed.It will beep during the upgrade process, this may take a few minutes.
#CHANGE SD CARD SERIAL NUMBER UPDATE#
Press OK to select your embosser model (Basic-D or Everest-D) and the embosser will start a new update process.Use UP or DOWN keys to select your model of embosser.Press OK to open the listing of embosser models.The embosser will restart as Index Braille universal (without defined embosser model).Plug in the power cord and the embosser will restart.Insert the second SD-card containing the latest firmware version.Step 2: Upgrade to latest firmware and select embosser model Unplug the power cord by gently pulling on the rectangular area near the power contact to the main board.This process loads a new version of the LINUX operation system into the embosser. The upgrade is completed when the beeping stops.
It will beep during the upgrade process, this can take up to 10 minutes.
Press OK to enter model selection mode.When the embosser has started up it is in Index Universal mode.Insert the SD-card labeled "1" in the embosser and power on.Step 1: Upgrade to new Linux operation system Please follow the instructions below carefully : Request the series of two SD-cards and they will be sent free of charge. To upgrade from firmware 1.1.x with SD-cards, first contact and request an SD card update for your embosser's unique serial number.
What are you looking for? Upgrade firmware 1.1.x via SD card-X
0 kommentar(er)
